Tried making my first "Easy Flange", it didnt turn out as well as I had hoped. So i did a lil experimenting. This is what I came up with:
Use #4 (vs #6) bare copper wire.
1) Wrap wire around pipe prior to hammering the wire.
2) Tapped the outside edge of ring to 30-40 degree angle
3) Solder on and be done
With this method, you dont have to "build" up the flange with solder.
It takes less than 10mins before its time to solder on.
Two of them can be joined together w/ a tri clampOh, and credit goes to RumBull for the Original Easy Flange