Anyone modified a Brewhaus Parrot?
Moderator: Site Moderator
Anyone modified a Brewhaus Parrot?
So I ordered a Brewhaus Parrot when I ordered my still. I wasn't sure how the fit up would be or what the angles were when I ordered it. Apparently, it is setup to run with a length of alcohol resistant hose between the outlet of the condenser and the inlet of the parrot. I am wanting to get away from any and all rubber in my set up and this would be the last piece. Has anyone modified a Brewhaus Parrot to have a cup on it like some others I have seen? Pics or thoughts would be helpful.
I'm gonna invest in stocks and bonds. Lace stockings and "un"Bonded Whiskey.
Re: Anyone modified a Brewhaus Parrot?
I'm not seeing a problem. Just drill a hole in a cap and solder it on. Or attach it directly.
Life is a journey you take alone. Make sure you do what you what makes you happy
Re: Anyone modified a Brewhaus Parrot?
pfshine wrote:I'm not seeing a problem. Just drill a hole in a cap and solder it on. Or attach it directly.
That's what I was thinking. Although the cap would be copper most likely and the parrot is stainless.
I'm gonna invest in stocks and bonds. Lace stockings and "un"Bonded Whiskey.
Re: Anyone modified a Brewhaus Parrot?
You can solder copper to ss. Just need the right flux.
Life is a journey you take alone. Make sure you do what you what makes you happy
Re: Anyone modified a Brewhaus Parrot?
Pretty sure I got it figgered out....pics to come once I'm done with it.
I'm gonna invest in stocks and bonds. Lace stockings and "un"Bonded Whiskey.
Re: Anyone modified a Brewhaus Parrot?
I'm curious about how this turned out since I'm wondering what is the best way to do the exact same thing.