straightening dead soft rolled copper

Fittings, parrots, packing, tooling and so on.

Moderator: Site Moderator

Post Reply
User avatar
bronctoad
Site Donor
Site Donor
Posts: 165
Joined: Sat Oct 15, 2016 5:16 pm
Location: middle of vacationland

straightening dead soft rolled copper

Post by bronctoad »

Alright I read in here somewhere that using soft rolled in condensers/deflegs, or other straight uses is a pita :evil: . Along time ago a mentor of mine, we jokingly called him bfi (big f#$king indian) :lol: showed me a trick for running nice straight coppers lines using dead soft. Not only was he a mentor he was an idol. this is his "Indian Trick" :wave:
first you need two points that won't move with the strain of a chain fall/come alongs or whatever jou can pull with, a way to attach the copper between the points. I'm going to use a piece of square tube for a short piece of 1/2 od.
Attachments
stuff I'll use
stuff I'll use
User avatar
bronctoad
Site Donor
Site Donor
Posts: 165
Joined: Sat Oct 15, 2016 5:16 pm
Location: middle of vacationland

Re: straightening dead soft rolled copper

Post by bronctoad »

all mounted
all mounted
once you get every thing held down, I flattened the ends to c-clamp them to the tube and the hook on the come-along,
crank it tight :wtf:
Attachments
pull till its straight.
pull till its straight.
User avatar
bronctoad
Site Donor
Site Donor
Posts: 165
Joined: Sat Oct 15, 2016 5:16 pm
Location: middle of vacationland

Re: straightening dead soft rolled copper

Post by bronctoad »

just tighten till its straight an smooth running your hands down it. if your worried about using it with compression fitting just check the od and only pull it down .010 to 015 thousenths it will still work. there is some waste because of mounting/clamping. I've wrapped the end of the tubing around the hook twice before and that worked, just waste a bit more. it doesn't take a whole lot to stretch the dead soft but it does work harden it as it straightens so you'll need a bender to shape after your done.
straight as an arrow
straight as an arrow
I hope this helps someone :wave:

bronctoad
cob
Master of Distillation
Posts: 2691
Joined: Sun Jul 26, 2009 4:38 pm
Location: little puffs of dust where my feet used to be

Re: straightening dead soft rolled copper

Post by cob »

vise grips do a good job of not wasting to much material.

if you weld a small chain link to the adjuster screw their perfect.
be water my friend
MrBee
Novice
Posts: 45
Joined: Wed Mar 02, 2016 4:26 pm
Location: Not close enough to Blue water

Re: straightening dead soft rolled copper

Post by MrBee »

They make a tool for that but it is very pricy unless you were gonna use it a lot.
Looks to me like your method would work fine for anything I would need.

http://www.eastwood.com/tube-straightener.html" onclick="window.open(this.href);return false;" rel="nofollow


MrBee
Post Reply