Hi,

Just purchased this drok led 4 in 1 multimeter, I am using it with Auber DSPR 1 Voltage Regulator, and quite happy with it, the only drawback is it shows the wrong Amp or Watt, the watt looks ok because this regulator is linear I tried it with a small kettle first to see in how many minutes it will boil the water for example it boiled 1 lt of water in 4 minutes at 100% power and when I did boil the same amount of 1 lt water at 50% it did it in 8 minutes so I can say that it is linear, and the watt is also cut by half but please look at the pic the amp is showing 5.08

Volt: 223.8

kW: 780

So Watt / Volt : Amp

780 / 223.80 = 3.48 amp but it displays 5.08 I do not know why it does that I use the DSPR 1 in burst firing mode anyone faced a similar problem ?

how can I correct it ?