I got bored waiting for my parts for my new build. Rad suggested that may need a cold finger. Don't mind the crude drawings I did them in PowerPoint.
I wanted to make something that required little or no soldering.I looked at the copper that I had and this is what I came up with.
[img] [/img]
[img] [/img]
I hope I didn't over or under think this. I would like some feed back if you please.((Okay I lied you do have to solder the 3/4" end cap, depending on what you are building the fins could be optional.)) I also added fins on the 3/4" end cap and i will twist them about 30 degrees to add a swirling affect in the condenser and act like heat sink for better cooling lower in the tube. This is what I'm going to stick it into. http://homedistiller.org/forum/viewtopi ... 87&t=61374
Im still learning.
Thanks ahead of time for your comments
PS it took me a bit to figure out to convert PDF to JPG then place it on my post. Its much better now.
solderless reverse liebig/concentric cold finger
Moderator: Site Moderator
solderless reverse liebig/concentric cold finger
My copper porn pot and thumper
Novice Guide for Cuts (pot still)
Advice- For newbies, by a newbie
You've got to be able to crawl before you can walk!
Novice Guide for Cuts (pot still)
Advice- For newbies, by a newbie
You've got to be able to crawl before you can walk!
-
- retired
- Posts: 3452
- Joined: Tue Feb 10, 2009 9:33 am
- Location: brigadoon
Re: solderless reverse liebig/concentric cold finger
You'd hearing crickets because no one can figure out what your trying to do. I'm not following your idea, granted I'm not to sharp but I'm lost on this one.
Ideas are like rabbits. You get a couple and learn how to handle them, and pretty soon you have a dozen. John Steinbeck
Re: solderless reverse liebig/concentric cold finger
Copper scrubbie is pointless, vapor won't even get a chance to reach it with the overkill cooling. How you plan on collecting product?
Seems like we are missing the other 80% of the design.
Seems like we are missing the other 80% of the design.
People say that I'm a bad influence. I say the world's already f#cked -- I'm just adding to it.
Re: solderless reverse liebig/concentric cold finger
Is this going on an LM or VM?
Sent from my SCH-I535 using Tapatalk
Sent from my SCH-I535 using Tapatalk
Re: solderless reverse liebig/concentric cold finger
I apologize I should have posted all of this on same thread. this is link to other thread.
http://homedistiller.org/forum/viewtopi ... 87&t=61374
http://homedistiller.org/forum/viewtopi ... 87&t=61374
My copper porn pot and thumper
Novice Guide for Cuts (pot still)
Advice- For newbies, by a newbie
You've got to be able to crawl before you can walk!
Novice Guide for Cuts (pot still)
Advice- For newbies, by a newbie
You've got to be able to crawl before you can walk!