The cleaning run at end I was close to 5500 watts.
I'm not sure I figure the ffv I ran today was 4000 to 5000w to start if temp wavers at all just bumped power up a little. I can run at full 5500 and did on the sac run at the end and could have used more power.
I tried lower power but takoff was alot slower and no different in quality at the higher speed. I found at beginning the strip run I was at 5500 but got close to comming out the top so backed power off and stabilized and then tweaked power till almost a vibration or sound could hear feel when column seamed to get to the magic fluidized bed I also did with the copper blocker but seams way more effective for spp.
I am sure after this is done no more strips. I figure my plan to run these one and done will b the following:
1) get column equalized and take forshot.. I noticed temp was 172f or so for this.
2) pull heads till clean ... this seams not long seams just after hit 172.3 things were pretty clean. Slight graininess and sweet taste about it.
3) pull hearts maybe 3/4 or so of expected hearts and then slow things a but to help keep hearts cut wider
4) likely not pull tails and just stop unless doing making pure whiskey.
B