Here are the parts that I’ve purchased so far. I have also ordered some PTFE gaskets that I do not have yet. The large white sheet is PTFE that I have cut into a large gasket between the pot and cover. I am going to request quotes to do the following job:
2. TIG weld the 316 Stainless Steel ferrule in the hole that was drilled using stainless steel filler so that the top of the ferrule is level with the surface of the bowl.
-- a. Do not use soft steel filler.
-- b. Minimize the amount that the ferrule protrudes into the bowl not to exceed 0.25 inches.
The things I’m hoping you guys can help me out with are:
1. Should I include any specific request about the gas or is that a standard thing?
2. Is not knowing the type of stainless that the bowl is made out of a deal breaker?
3. Is anything that I’ve put here incorrect or incomplete?