Pot still design,I have changed mine again

[jdonly1]

I know it still not welded but how does this look.
I took out the T and fitted a 90 deg bend and a 45 deg bend

[Hawke]

Looks like a potstill
Before you weld it all together, mock it up where you plan to run it. (It's a pain having to put your collection jars on the floor)

[punkin]

Looks very familiar. And should work a treat.

They're tops those copamate flanges. I use the four inch one and have a four to two reducer, just so i can stick my arm in the keg.

[Rudi]

I think I have seen a still like that somewhere before And Yes it is a pain in the arse(back) having your collection jars on the floor I was planing on going back to gas so the collection point was lower than the flame but now I 've got the lectrikery hooked up and sussed out I dont want to cut into my stillin time to build a wheel rim burner.

[jdonly1]

Thanks boys

[sconly]

Looks good jug head nealy the same as mine fancy that all you need is to get it welded so pull your finger out and get it dun