Slant Plate Templates

[johnthemann]

Good morning all...long time lurker and learner first time poster. I am in the process of building a 2" dual slant plate boka and just got finished with my condenser and am ready to start on the top column. I remember seeing a few months ago a template that you could tape to the column for precise cuttting. I have searched and searched and for some reason I cannot find that PDF file. Any help would be greatly appreciated. This forum is fantastic and a wealth of information. Thanks in advance!!

[Bushman]

Try this link:
http://homedistiller.org/forum/viewtopi ... e#p6815368

[johnthemann]

Thats it thanks much!!

[Ono Nadagin]

here is a revised template by usge it is a little easier to use... its about half way down the page

http://homedistiller.org/forum/viewtopi ... &start=180