New to distillation, or simply new to the HD forums.
** Your first post MUST go here. Introduce yourself and tell us a bit about your interest in distilling. Any posts asking distilling questions will be deleted. **
But I've acquired a bunch of scrap 2.5" copper that I plan on using, anyone have a template for making the cuts at the correct angles on a 2.5" pipe? So far it's eluded me!
15.5 gal keg for a boiler and 40" column are the other components, Any recommendations or suggestions are greatly appreciated!
"If the whiskey don't kill me, I'll live till I die"
Welcome knucklhed, Can't help you with the boka, I see one in my future but have not tried one yet, someone will jump in and help ya out. Just a welcome and keep us posted. OMD
Sometimes I wonder why is that Frisbee getting bigger......and then it hits me.
Sorry I's taken so long to get back here - just finished a big project that delayed my still build...
Yeah that's the one - I think I've got the solution to making the correct diameter plates, just trace around the outside dia of the pipe I'm using, but what about making sure I get the plates exactly opposite?
Thanks for the help!
"If the whiskey don't kill me, I'll live till I die"
Quick question...
I have my boka build plotted out, but there are a few things that are "different" about my build that I haven't seen covered anywhere and I would like the opinion of the experienced folks around here, what is the appropriate place to start that thread? Was kinda thinking that "My first..." might be the place, but after reading through there it looked like it was more about pics of first builds, runs, mashes etc...
Thanks!
"If the whiskey don't kill me, I'll live till I die"
