Need some electrical advice again.
I was a little to aggressive in tightening one of the low voltage lugs on my Auber SSVR 40A solid state voltage regulator. The small brass connector shown in the picture pulled out of its location. The brass lug has a small brass tip at the end. Does anyone know if that was attached to anything within the SSVR or just soldered to the board or both. Can’t see inside the hole. I don’t know if I twisted off a wire at the end of the tip or if it just soldered to the board.
I have ordered another just waiting for is arrival.
ELECTRICAL HELP SSVR DAMAGED
Moderator: Site Moderator
-
Slow42
- Swill Maker
- Posts: 194
- Joined: Wed Jan 01, 2020 8:51 am
- Location: East coast
ELECTRICAL HELP SSVR DAMAGED
You do not have the required permissions to view the files attached to this post.