I am looking to build a boiler/thumper using two 15.5gal kegs that will include a steam outlet valve to confirm steam is being produced prior to directing it into the thumper. (A - B in the drawing below; valve will be at the end)
In a second configuration, I would like to direct the steam into a 35gal HDPE mash barrel. (A - C in the drawing below; steam outlet valve will be moved to the middle)
In either case, I would like to tri-clamp a 1/2” ball valve to shut off the flow of steam once it has begun thus diverting it to the vessel.
I have copied this idea from Scarecrow’s steam rig here.
Will this work?
TIA
Twisted Brick
EDITED for clarity
Thumper/Stripper Design
Moderator: Site Moderator
-
Twisted Brick
- Master of Distillation
- Posts: 4213
- Joined: Sat Mar 09, 2013 4:54 pm
- Location: Craigh Na Dun
Thumper/Stripper Design
You do not have the required permissions to view the files attached to this post.
“Always carry a flagon of whiskey in case of snakebite, and furthermore, always carry a small snake.”
- W.C. Fields
My EZ Solder Shotgun
My Steam Rig and Manometer
- W.C. Fields
My EZ Solder Shotgun
My Steam Rig and Manometer