Truncated cone online calculator (link and practice test)

[Demy]

I found this calculator, calculate the measurements to be able to draw a truncated cone, we could report it on paper or sheet metal. I've seen other great posts here on how to draw it, this could be an added resource.

https://craig-russell.co.uk/demos/cone_calculator/

[Demy]

I tried to build a small cone that I needed. So I will test the correct calculation.

[Demy]

Here, cutting and welding is done quickly, not too careful.

[Bushman]

I am lucky as I have a solid modeling software that converts a 3D model to a layout minus the tabs. It also calculates the volume so if I am building a 15 gallon boiler it figures it out for me. Your link and others we have on the forum are very helpful for those that don’t have access to software.

[Yummyrum]

Nice work again there Demy

[Demy]

Thank you all. There are many software that can do this (great idea to use them for example for boiler construction). this is mainly for simple constructions or fittings.

[Demy]

A practical application, use as a reduction.