Bubble plate question

uncle_jack · Post by **uncle_jack** » Tue Feb 09, 2021 5:06 am

Hi all,

i just finished building my 3" bubble plates with 3 bubble caps and 1 downcomer on each plate.

When putting some water on the plates, i saw that they are not holding water for an infinite amount of time, a tiny amount is leaking through point where the risers and the plates meet.
To give you some numbers: It takes like 5 minutes for 1/2 oz of water to drain from the plate.

Now my question: Do you think that this tiny leak will cause any noticeable problems when running the plates?

Cheers, Jack

This topic has 3 more replies

You must be a registered member and logged in to view the replies in this topic.

Register Login