Does it matter if column not 100% vertical?

Post by **EricTheRed** » Wed Jan 12, 2022 5:35 am

Hi

Been wondering this for a while

My 30 L boiler has a 2" bulkhead adaptor, then immediately goes from 2" to 3" via an adaptor. A 700mm packed column then sits on that, followed by another 3" to 2" adaptor, before going to the 2" shotgun.

image.png

similar to pic
Now, both of those adaptors (thermowells) are not 100% - the 2" ferrel is not welded on perfectly

as a result, the column does not sit perfectly vertical.

Is that a problem?

From what i can see, there doesn't seem to be, but what does the forum think?

This topic has 15 more replies

You must be a registered member and logged in to view the replies in this topic.

Register Login