What if you couldn’t see your bubble plates?
Moderator: Site Moderator
-
Gonzo_distills
- Novice
- Posts: 53
- Joined: Thu Jan 28, 2021 7:07 am
- Location: Appalachia
What if you couldn’t see your bubble plates?
Long story short here is flatened 2” pipe run through the mill and lathe. The rest are self explanatory bits. The assembly is bound by 1/4” tubing and the whole thing slides down into a 36” column with stops 6” above the connection to the pot. Stripping runs are done without it slid in and spirit runs with. Helps to put a half handful of beads in each level as it goes in. Consistently runs very high proof.
You do not have the required permissions to view the files attached to this post.
Maintain a continuous ground at all times!