After the previous topic about coil in bucket vs liebig, I decided to make another coil condenser. The previous one was made out of 4m long, 22mm diameter copper coil in 65 liters PVC bucket. The new one I want to be made of 5m long, 18mm diameter copper coil in 40 liters PP bucket. The bucket will be narrower and taller.
My question is, how should I bend (twist) the coils so that it will turn out nice, without strangulations (flattening)? I know there are a few tricks:
1. Fill the pipe with sand or fine salt then bend.
2. Fill it with water, close the heads and solder, then bend.
Do you have any better ideas?
New coil in bucket condenser
Moderator: Site Moderator
-
Iulistoi
- Bootlegger
- Posts: 112
- Joined: Sat Nov 07, 2020 7:19 am
- Location: Bucharest, Romania