It's easy to scale down basic still designs. For a VM, just go with a 2" column, 2" tee, reduce down to a 1" gate valve. Precisely how you do it will likely make very little if not any difference in how it behaves. You will benefit with a taller column.
For instance I went with a short tee so the vapor takeoff wouldn't be unnecessarily long. I made and installed/soldered a copper thermowell into the reducer so I can monitor the vapor takeoff temp.
tri-clamp short tee.png
I went into this hobby knowing I'll likely be doing this for a good number of years so I stepped up to a 3" column rather than a 2". I wasn't going to commit to a 4" because I wasn't confident I'd have multiple 240V circuits at the time and I already had 15.5 gal kegs for boilers. 3" is faster producing than 2" and I'm glad I made it larger. If copper is more expensive then just go with stainless Tri-Clamp spools instead. Multiple spools can be connected to make the column.
It would cost less to simply weld a Tri-Clamp ferrule to the top of your keg rather than spending more money on reducers, gaskets and clamps. It just takes a little time, effort to cut, grind and simply have someone TIG weld the ferrule to it once you've done all the work. After welding, if there's anything that needs ground smooth then I take care of the finish work myself. An angle grinder and a Die Grinder are must have tools in my opinion when it comes to fabrication work for stills.
Also think about how you intend to do stripping runs. You can use your column segments as your pot still riser. There are different ways to do the same thing, but you can use two 90 elbows, your reducer then a product condenser.
You do not have the required permissions to view the files attached to this post.