when to stop a stripping run

[terryt]

hi everyone - I would like to try a stripping run tomorrow. I have done some reading on it, but I'm not totally sure when I should stop at. From what I can remember, anything after 92 degrees should not be collected. I think I read somewhere else to stop at a slightly higher temp of 96 degrees. I don't know if this applies to stripping or just a regular run. Most likely a regular run. Would these same temps be recommended for a stripping run ? I am thinking that 96 degrees would capture pretty well everything from a stripping run, even the bad stuff.

I would also like to monitor the % I'm getting. What % do you usually stop stripping at ? And what % would you stop at during a regular run to avoid tails ? I will be using a reflux column unit with an internal coiled condenser, as per the bokakob mini -

thanks in advance, t