I was about to try and bend the T part of my tee up at a slight angle to stop any pooling. Just as I'm getting ready to try, the thought of throwing away 45 bucks on a tee,added some doubts. I was planning on heating that section up with a pipe inside and pry it upwards. Anyone here tried that. I know copper is malleable but can't afford another tee right now or the time to get one shipped.
Tōtō
Copper tee ?
Moderator: Site Moderator
-
Tōtōchtin
- Member
- Posts: 717
- Joined: Sun Jul 03, 2022 5:13 pm
Copper tee ?
Si vis pacem, para bellum