Cutting glass?
Moderator: Site Moderator
-
Steve Broady
- Distiller
- Posts: 1572
- Joined: Thu Aug 25, 2022 9:52 am
- Location: NC Piedmont
Cutting glass?
Has anyone tried to cut the glass tube in an in-line sight glass? I have a couple 2” TC sight glasses with 100 mm long tubes, and I’d like to cut the glass in half and install a plate in the middle of that. I’ve got a cheap diamond wet saw made for tile and stone work, and I was thinking of trying to use that to do the job. Has anyone else done anything similar, otherwise have any advice?
Too much of anything is bad, but too much good whiskey is barely enough. - Mark Twain