My last project for 2026 is going to be my most ambitious yet. I thought I'd share my plans with you. I want to make a Bourbon with a high rye content, using a mix of raw rye and malted rye. Since I want to stick it into my new 20L/5gbarrel, I am planning to make about 25-27L/7g of product in total. I've never made this much whiskey before in one project. I call it Red Diamond Whiskey.
Having had a bad experience from making high rye Bourbon last year, I am being a bit more moderate with the amount of rye this time. In the long run though, I want this Whiskey to have at least 30% rye but for now I am content with 20% rye. The remaining grains are 68% corn and 12% barley malt.
The Rye
I like the flavors from malt and I think rye malt makes a lovely addition in whiskey. However, during this year my interest for heirloom grains have grown from non-existent to big, and I have decided that the raw rye element of the mash bill should not only be heirloom rye, it should constitute 2/3 of the rye portion.
Being the main flavor ingredient in rye Bourbons, I've researched rye in distilling is a lot. In commercial Bourbons, it seems to be all about raw rye. After researching wheat, realizing how far commercial wheats have come from the original wheats we used just 150 years ago, I have understood the same goes for rye. However, a number of small scale Whiskey producers in the US are trying out older, heirloom, rye varieties. Rosen rye is often mentioned, as is Abruzzi rye, and used by a some craft distillers. However, on this side of the pond neither are available. The good thing is that the interest for heirloom grain is global. In Germany, a big consumer of rye bread and thus a big producer of rye grains, several heirloom rye varieties are making their way back.
In my research I made a friend in German farmer and grain distributor Reimund Wiederhold from WIDU Mühlenbau. His locale is near Rotenburg, 45 minutes south of Hamburg, which is a grain growing region as much as any. One of his heirloom ryes is the Champagne rye, aka Champagneroggen. It has its' origins in the north of France, from the area of Champagne, but I am unsure if it is still grown there. The French affiliation with wheat seems to have forced the Champagne rye to emigrate east. After some deliberations, I decided to go with Champagne rye as my raw rye component in Red Diamond. On my way back from Portugal this summer, I stopped by Reimund at his farm, and picked up 14kg/31lb of his Champagne rye.
Champagne rye is supposedly slightly nutty, milder and sweeter than normal rye. It's considered a bit more refined than normal rye. How it will show up in distilled format is unknown to me.
I will also use rye malt. Two types: pale rye malt and crystal rye malt, equal amounts. Both provide a bit spicy crackers flavor that I particularly like.
The Corn
Calling the Whiskey Red Diamond is not entirely picked out of the blue (pun intended). I've wanted to make a Bourbon using the red corn varieties Bloody Butcher or Jimmy Red, but just as with the US heirloom rye varieties, neither are available in Europe. In Europe, however, several countries are growing more than just yellow dent corn. The Italians love flint corn for their Polenta and one of their highest prized corn varieties is a red heirloom variety called Pignoletto Rosso. It's possible for me to get it as course ground flour but not whole, which is what I want. In Portugal, there's the Milho Rei, another red corn variety, and when I was in Portugal this summer I contacted several grower who say they have Milho Rei but all were out. It's a popular variety and sells out soon after harvest, a lady grower told me.
And in France they grow two red varieties that both are used for pigeons: Bordeaux Cribbs and a variety that is often just called Red Corn, or French Red. Since I have made a friend in Sweden's leading pigeon racing club, I am able to piggy back from his club's shipping from Belgium and buy both types of red corn. I will use both in my Red Diamond.
I have also been able to harvest at least two ears of my own grown Atomic Orange corn, which I will add to the mash bill. We are talking about max 20 kernels, but probably the best corn in Sweden.
The Barley malt
Finally there's the 12% of barley malt. The heirloom focus continues and I will use Chevallier malt from the UK. Chevallier is a old variety that was very popular all over Europe in the 1800's and very popular with brewers because of the strong malty flavor it provides. It fell out of fashion at the turn of the century as brewers fancied Maris Otter and distillers fancied Golden Promise instead. But Simpson's maltster has brought the barley variety back and it has become popular with hobby brewers and hobby distillers alike. I've used it in my Green Diamond recipe and liked it.
The Recipe in short
68% Red Corn
20% Rye (12% Champagne rye, 8% rye malt)
12% Chevallier Barley malt
The process
I will use YLAY for cold mashing and fermentation. For each batch, I will use 13kg/29lb of grains with 45L/12g of water, in a 60L/15.5g barrel. The grains will pre-soak in 25L/6.5g water, starting at 68C/154F, then allowing it to fall in temp over 4-5 hours. The soaked grains are brought to pitching temp by the addition of the remaining 20L/5g water, coming cold from the fridge. Typically, these batches give me a wash after draining and separating gunk of 37L/10g.
I considering if I should soak the rye first in 45C/113F water for a 30 minutes combined beta-glukan and protein rest. I will normally do a beta-glukan rest when mash traditionally and there's rye or oats in the mash bill, however if it's really needed for YLAY mashing I don't know. I am thinking it can't hurt but it may just be a waste of time. I also considering to add enzymes for the beta-glucans. I've got this Polish enzyme that is supposedly good for rye batches. I don't have experience with raw rye so I'm not sure what to expect when it comes to rye goo.
As I want about 25-27L/7g of product to use in the barrel, I will need to split the project up in three spirit runs. Each stripping run will give approximately 12L/3g low wines at 25% ABV.
- 4 stripping runs and 1 spirit run (no feints available)
- 3 stripping runs and 1 spirit run (with feints)
- 2 stripping runs and 1 spirit run (with feints)
This project will keep me busy up to and over xmas.
... and in conclusion
My idea with getting a 20L/5g barrel was to get into fewer projects. Focusing on one or two whiskey projects per year to fill the barrel up, then have time for other things. Then I realized how much work there is to just fill a 20L/5g barrel. Working with 60L/15.5g barrels is fine for shorter projects but when you need to make so much wash one needs to do a lot of batches. I've been contemplating to upgrade to bigger volumes but I am pushing that for the future. So 9 batches it is.
A couple of things concern me:
- Rye is a b*tch sometimes but with malted rye I've been spared the goo and the stickiness. Should I expect much more pain and grief with raw rye? Tell me your best rye story, if you have one?
- YLAY and rye seem to work fine, have anyone actually had rye-related problems with YLAY?
- Scorching. I am running internal elements, be it wavey ULD elements, I am not safe from scorching. I don't have a steam stripping set up and will not have it for this project either. I will be running very carefully the first stripping runs before I feel how fast I dare to run, spreading the heat over both elements.
Still, I am really looking forward to using the raw Champagne rye.