Modification to power box

If it plugs in, post it here.

Moderator: Site Moderator

Post Reply
User avatar
BigSwede
Distiller
Posts: 1006
Joined: Thu Feb 06, 2014 10:36 am

Modification to power box

Post by BigSwede »

In my recent stripping activities, my 10 year old power box worked well. But I noticed that the minimum power I could dial up was 900 watts. I want lower than that for some future still processes if needed.

It's a phase angle controller, 25A, 240VAC, 5500W element. I have a ten turn potentiometer on it which I really like because I can fine tune the shit out of it, almost a watt at a time. But why won't it go below 900 watts?

Opened her up, and the pot is 125K, not 250K which is the data sheet recommendation for this PAC. There you go. Zero ohms = full power, 250K = min power. I priced 200K, 250K 10-turn pots and the price point is insane, over $100 in many cases.

Here is what I came up with as a simple solution.
Powermod2.jpg
For normal use, with the Hi/Low range switch closed, I get 900W to 5500W. Open the switch, the 125K 2W resistor is added to the pot, and I should get min power out to some mid-range wattage.

Think this will work and give me a cheap option?
You do not have the required permissions to view the files attached to this post.
User avatar
shadylane
Master of Distillation
Posts: 12879
Joined: Sat Oct 27, 2007 11:54 pm
Location: Hiding In the Boiler room of the Insane asylum

Re: Modification to power box

Post by shadylane »

That will work.
User avatar
Corn Cracker
Posts: 1398
Joined: Sun Jun 13, 2021 7:25 am
Location: s.e. Texas

Re: Modification to power box

Post by Corn Cracker »

You electrical engineers amaze me
I think I'll go home and fire up my still, it might not make me feel better but, I bet it will
User avatar
BigSwede
Distiller
Posts: 1006
Joined: Thu Feb 06, 2014 10:36 am

Re: Modification to power box

Post by BigSwede »

Thanks Shady, I'll give it a try. I don't think I'd use less than 900 watts very often, but it irritated me.

CC, I know just enough to still be alive and not electrocuted!

A long time ago, I found this "Two Pot" diagram here on HD and saved it. Probably better than what I'm thinking. You have coarse and fine adjustments with this, very nice. Adjust the pot values per your system. Whoever did this, thank you.
twopots.jpg
You do not have the required permissions to view the files attached to this post.
Post Reply