All I used was water, no glycol. It was in a basement so no fear of freezing. The water did cook off its chlorine content, so an additive to help keep algae from forming would be a beneficial, even if it’s just a splash of pool chlorine or bleach.Yummyrum wrote: ↑Fri Nov 13, 2026 11:16 pm I’ve never really looked at using a radiator as a cooling device as have always had ample water . But it seems that the car radiator makes the most sense .
Typical 100kw IC engine is at best 30% efficient ( turned into movement ) . Roughly 30% goes out the exhaust as heat and the remaining 40ish% engine block heat gets cooled by radiator .
So hell , if a car radiator can remove 40kW of heat , that has to be a winner .![]()
And a car stopped at the lights is probably idling and so the thermatic fan kicks in . Removing a good 5-10kw while it’s stationary .
I think I see a new project . I guess it does involve Glycol . I wonder if using water in a non pressurised system would provide the same level of heat removal .
And a safety plug about using food grade Propylene glycol as apposed to poisonous Ethylene glycol which is the common car radiator coolant. .
Empty Glass may have been the one that I followed on my design. The idea came from this forum, I just adopted it. The radiator I used was a 1992-2000 Honda civic 3 row core. I think it was about $70 brand new off of eBay back then.
Speaking of cooling efficiency. A typical IC engine in a car uses a thermostat to maintain a preset temp. It will regulate flow to keep a set temp. I’ve seen a few engines overheat due to not having a thermostat. The water doesn’t get enough time in front of the fan before going back to remove more heat. That’s why I say keep the water flow to a minimum on the condensers to maximize efficiency. It will heat up an area a bit. A small shed may want to plan accordingly for the extra heat.