Steam Stripping 100% Rye on grain - First impressions

Steam powered cooking and distillation devices.

Moderator: Site Moderator

Post Reply
User avatar
Dr Griz
Swill Maker
Posts: 175
Joined: Mon Apr 19, 2021 5:08 pm
Location: Stowed away aboard the flagship of a pirate zeppelin armada

Steam Stripping 100% Rye on grain - First impressions

Post by Dr Griz »

After about a dozen runs dialing in the process on my steam injection rig (just an overgrown thumper with water in the boiler), I decided to try distilling on the grain. I haven't yet done a spirit run (let alone aging), so I don't have anything to offer about cuts or the impact on flavor yet, but I wanted to share what struck me so far.

This is a 100% rye wash that I've done a few time before: 36 lbs. unmalted rye, 9 lbs. malted rye, and 20 gallons of water. My OG usually reads about 1.070 (take that with a grain of salt -- I hear that gravity readings on rye washes aren't very reliable).

Last time I ran it, I pressed the wash off the grain with a mop bucket, yielding 17.5 gallons of uncleared wash (which was stripped with steam). This time, I ran all 22 gallons of wash and grain in the fermenter.

As I expected, it proved MUCH easier to separate the spent grain from the stillage after distillation than to separate the grain from the wash before distillation. And my compost bin smelled much less suspicious! :lol:

But what I didn't expect was just how much more yield this one change would produce: My earlier 17.5 gallon wash run yielded 4.75 gallons of low wines at 32% ABV; this time, I produced 6 gallons of low wines at 30% ABV. That's more than an 18% increase in yield!

One more interesting datum (at least to me): my back-of-the-envelope calculations suggest that, at the beginning of fermentation, my fermenter held 23.6 gallons of grain and water. After two weeks, it was down to 22 gallons -- presumably that extra gallon and a half blew off as CO2...
qui bene bibit est beatus
Post Reply