Union joint leak
Moderator: Site Moderator
-
rbsc
- Bootlegger
- Posts: 118
- Joined: Wed Feb 12, 2020 6:30 pm
Union joint leak
I’ve been pretty proud of my soldering job, no vapor leak so far. But I cannot stop a little drop of liquid from dripping out this joint now and then, unless I crank it down unnaturally tight. Obviously, I have a strip of Teflon under there. I mean I’m cranking on this thing so hard I’m afraid I’m going to break something. Is that something that would make you shut the whole thing down? For now I have wrenched it so tight I think it has stopped, but that happened about 15 minutes ago and sprung another little drop.
You do not have the required permissions to view the files attached to this post.