DIY Stainless/Copper Funnel
Posted: Mon Jul 20, 2009 5:05 pm
Due to the fact that the only funnels i could find were plastic (and you all know what we think of plastic) and I really wanted a funnel to sit on top of my collection bottle, so finally I had a bit of inspiration the other day and built my own, and it only took 5 minutes.
The bowl is a cheap stainless bowl from Ikea that cost me about 2 bucks. The run off is slightly off centre because the bowl already had a small hole in it, so I just drilled that out further. It only took about 10 seconds to heat to brazing temp with my mapp torch, and just a quick clean up and it was done... It would also be very easy to upscale this, even to a big funnel for charging the still
Aces
The bowl is a cheap stainless bowl from Ikea that cost me about 2 bucks. The run off is slightly off centre because the bowl already had a small hole in it, so I just drilled that out further. It only took about 10 seconds to heat to brazing temp with my mapp torch, and just a quick clean up and it was done... It would also be very easy to upscale this, even to a big funnel for charging the still
Aces