Complete reflux still build...
Posted: Wed Jul 29, 2009 1:09 am
As with my pot still build, i thought this may be of some help to some noobs....
Pictures tell most of the info...
Building the coil.... I think if i did it again id wind a lot more coils....
With end cap inside 12" tube....
At the bottom of the 12" tube is the T section in another end cap....The other coil in the shot is just one i wasnt happy with...
Overflow and take off tap.....
Lower section and take off lay out....
After a couple of runs i thought this pot scrubber inside the condenser made quite a difference. Probably because i didnt really have enough coils in the condenser maybe?
This is by no means the greatest build around but it produces 93% no problem.. I just thought some build photos could help some crew out....
Also i run a temp gauge just below the T section which i have no photo's of....
Cheers all.....
Pictures tell most of the info...
Building the coil.... I think if i did it again id wind a lot more coils....
With end cap inside 12" tube....
At the bottom of the 12" tube is the T section in another end cap....The other coil in the shot is just one i wasnt happy with...
Overflow and take off tap.....
Lower section and take off lay out....
After a couple of runs i thought this pot scrubber inside the condenser made quite a difference. Probably because i didnt really have enough coils in the condenser maybe?
This is by no means the greatest build around but it produces 93% no problem.. I just thought some build photos could help some crew out....
Also i run a temp gauge just below the T section which i have no photo's of....
Cheers all.....