Page 1 of 1

Hello All

Posted: Wed Oct 03, 2012 2:20 pm
by Deep In The Woods
H i everyone... im new to this forum and wanted to say hi ...im getting ready to build my 1st still ... real simple at 1st before i jump in with both feet ... :lol: ..I have a question ... i want to start off with a stainless steel pot with a copper condensor on top.. ill put copper tubing off of the condensor down into a worm with ice and hopefully drip into glass container .... does that sound good for starts ?... is there a certain type of stainless steel pot that i should use on a cheap budget ? ... thx and hello once again

Re: Hello All

Posted: Thu Oct 04, 2012 9:12 am
by hwy419
Welcome to HD.
Deep In The Woods wrote:ill put copper tubing off of the condensor down into a worm with ice and hopefully drip into glass container .... does that sound good for starts ?...
Just so you're clear: Heat Source >>> Pot >>> Stillhead/Tower >>> Condensor/Worm
Deep In The Woods wrote:is there a certain type of stainless steel pot that i should use on a cheap budget ? ... thx and hello once again
Find you a stainless steel beer keg. I pulled mine out of the woods that someone had dumped there years ago. Remove the center post. Viola!

Re: Hello All

Posted: Thu Oct 04, 2012 10:18 am
by OlympicMtDoo
Welcome to HD Deep in The Woods, Stainless and copper are good, ice on your coil is not so good, go to the distillation design section and have a good read and the rest of the site too. Then you'll have even more questions but you'll also have some answers, good luck and happy building. :thumbup:

Re: Hello All

Posted: Thu Oct 04, 2012 12:05 pm
by Prairiepiss
I'm kinda cornfused? You said you come off the pot to a condenser then from the condenser down to a worm in a bucket. Why would you need two condensers? Sounds kinda like you are wanting to build a pot still. But a condenser above the pot would be more like a reflux still?

Maybe you can explain it a little better for us? Or draw us a diagram. So we can get a good picture of what you are trying to build.

Re: Hello All

Posted: Thu Oct 04, 2012 4:37 pm
by Deep In The Woods
Sorry prairiepiss i used wrong term. :D off the top of the pot ..I want to put a two inch copper tube...like a chimney ...then start running copper tubing from the side of that..Down to a worm......Thx for the help

Re: Hello All

Posted: Thu Oct 04, 2012 8:11 pm
by BareKnuckles
Get a keg.. Best thing I've done... Got them free from craigslist... Oh yeah.. READ ,READ ,READ.... Lots of info to be had here!!!!

Good luck and be safe!