Home Distiller

Alright, So I built my first one a couple weeks ago. Wasnt very pretty, I used 3/8 ID copper 20ft. I cut alot of it off and did some soldering for the first time. It was pretty ugly I must say. Then I found this place and started getting ideas from other people. I want to keep it simple still, so I went and bought some new copper. I went with 1/2 ID this time bc I was having a hard time finding 3/8 fittings. Well I only went with 10ft this time and now Im worried I may have miscalculated. Anyways here is a pic of what I have so far. Obviously it needs connected, but I think you can get the idea.

Here is my question...Do you think there is enough piping from the Pot to the Condenser for it to work properly? I mean I can go snag another 10ft If I need to. I also have the 3/8 piping that I could run in the middle but a large to small and back to large diameter doesnt seem very smart. What you guys think? Be nice, noob here

just wanted to bump this one time, Do you guys think I have enough copper between the pot and the condenser for it to work. My gut says it will be okay, but I was also thinking about flip flopping my copper L long ways, and have the short end connected to the lid, I dont know if that even matters though, lol.