Page 1 of 1
2" column to keg
Posted: Sun Feb 10, 2013 10:04 pm
by DangitBuck
Hey everybody I have a quick question that hopefully is easy to answer. Would soldering a 2" ferrule to my column (seen here,
http://www.hillbillystills.com/Copper_t ... _p/cs2.htm ) connect to a 15.5 gallon sanke keg with a tri-clamp? Or do I have to use the whole copper pipe to keg kit from mile-hi?
This is my first time working with a keg and I've looked around on the sight and can't find a page about keg connections, thanks for your time reading this post!
Re: 2" column to keg
Posted: Sun Feb 10, 2013 10:18 pm
by Prairiepiss
Search for easy flange. And everlasting PTFE gasket to go with the easy flange.
Re: 2" column to keg
Posted: Mon Feb 11, 2013 4:35 am
by bellybuster
That piece already has a coupling attached, just slide your column in an solder
Re: 2" column to keg
Posted: Mon Feb 11, 2013 4:54 am
by Condensifier
I'm going to use this "easy flange" method for the extension I'm going to make for my 3". It looks pretty clean.
http://homedistiller.org/forum/viewtopi ... =2&t=13631
Re: 2" column to keg
Posted: Mon Feb 11, 2013 5:16 pm
by DangitBuck
Thanks everybody for the help:) ill definatly try that
Re: 2" column to keg
Posted: Mon Feb 11, 2013 5:39 pm
by condo33
I used the easy flange technique and everlasting PTFE gasket. Probably have a $1:25 in the whole thing and found it very easy to do.