reflux still design needs aproval
Posted: Fri Nov 12, 2004 2:42 pm
this is a design i have been thinking about i cant draw very well but here it goes.
the packing will be 1cm marbles and it has cooling water inside the column in a 1/4 copper pipe the column is 1m tall and 2" in diameter
on the product line there is a tee going to the reflux valve (needle) and to the output.
i need to know if this would be ok or do i need any corrections
the packing will be 1cm marbles and it has cooling water inside the column in a 1/4 copper pipe the column is 1m tall and 2" in diameter
on the product line there is a tee going to the reflux valve (needle) and to the output.
i need to know if this would be ok or do i need any corrections