2" shotgun vapor tube spacing
Posted: Fri Jul 25, 2014 7:51 am
About to complete my 2" shotgun build I started last night. consists of (7) 1/2" tubes inside a 2".
what a PITA with only hand tools. Made several sets of plates before I got 2 I was willing to use.
First attempt building a shotgun for me. I originally started with a 4 hole design, and ended up with a 7
Now, I'm wondering if I have enough space left for H20 to circulate efficiently? I'll be using city water so pressure and volume are not an issue.
Have I screwed this up? (before I waste a length 2" for the jacket.....)
If the spacing is too tight I'l could always cut the thing in half and make a couple cross flow condensers
(But knowing my luck they wouldnt be tight enough for that application!)
what a PITA with only hand tools. Made several sets of plates before I got 2 I was willing to use.
First attempt building a shotgun for me. I originally started with a 4 hole design, and ended up with a 7
Now, I'm wondering if I have enough space left for H20 to circulate efficiently? I'll be using city water so pressure and volume are not an issue.
Have I screwed this up? (before I waste a length 2" for the jacket.....)
If the spacing is too tight I'l could always cut the thing in half and make a couple cross flow condensers
(But knowing my luck they wouldnt be tight enough for that application!)