Stainless steel potstillhead
Posted: Mon May 25, 2015 7:58 am
It's been a while since i had time to build some equipment, but there were plenty of ideas circeling my head.
Due to a lot of help to other people, i hardly had time for all those ideas i have.
So i decided to be a little selfish and nurse my ego a bit.
My plan was to build a proportional splittinghead (it still is)...
Unfortunatly some material i had seen implemented in my build was used otherwise in the workshop.
So..determent not to leave the workshop empty handed, i improvised a little.
For a potstill i have my tee from my CCVM with a endcap on, only drawback is i have to disassemble it.
Not that it is an issue for me, but anyway i liked to have a head dedicated only for a potstill.
It's nothing special, but i would like to share my build with this forum. I hope it can inspire someone with similar ideas.
Hight: 220mm
Diameter (body) 2", Ø51 mm
Takeoff: 3/4" male threaded pipe on cone
Bottom: 1,5" ferrule
Fillerrod: Thyssen Krupp, Thermanit TG 316L
Gas: Argon
Due to a lot of help to other people, i hardly had time for all those ideas i have.
So i decided to be a little selfish and nurse my ego a bit.
My plan was to build a proportional splittinghead (it still is)...
Unfortunatly some material i had seen implemented in my build was used otherwise in the workshop.
So..determent not to leave the workshop empty handed, i improvised a little.
For a potstill i have my tee from my CCVM with a endcap on, only drawback is i have to disassemble it.
Not that it is an issue for me, but anyway i liked to have a head dedicated only for a potstill.
It's nothing special, but i would like to share my build with this forum. I hope it can inspire someone with similar ideas.
Hight: 220mm
Diameter (body) 2", Ø51 mm
Takeoff: 3/4" male threaded pipe on cone
Bottom: 1,5" ferrule
Fillerrod: Thyssen Krupp, Thermanit TG 316L
Gas: Argon