Page 1 of 1
My shotgun
Posted: Wed Nov 29, 2017 10:01 pm
by Tazewell
It's 1-1/2" diameter, its got 4, 1/2" chambers, it's 26" long and each 1/2" chamber is wrapped with a piece of 16 gauge wire. Brazed with 15% silphos. It also has a very pretty union on the end. I just added the reducers a few runs ago because distillate was sort of going all over If i didnt have it at a specific angle. Thanks.
Sent from my SM-S906L using Tapatalk
Re: My shotgun
Posted: Thu Nov 30, 2017 8:58 am
by just sayin
Looks nice, Taz! Should knock down what ever you throw at it.
Re: My shotgun
Posted: Thu Nov 30, 2017 12:41 pm
by Kegg_jam
How did you manage to get 4 - 1/2” inside a 1-1/2” pipe?
Re: My shotgun
Posted: Thu Nov 30, 2017 1:17 pm
by Twisted Brick
Most likely 1/2" OD. If I remember correctly, NcHooch fit 5 of them in a 1-1/2" shotty
Re: My shotgun
Posted: Thu Dec 07, 2017 12:20 am
by Reverend Newer
very pretty union on the end! Great job.