Home Distiller

Because at some point my aircooled product condensor was a bit too far away from my table, i added a length of 3/8" corrugated stainless steel pipe to get to the parrot.

During that run, I raised the heat and shut down the reflux to speed up the tails. As the condensed product temp was going up because of the speed, it was throwing off the abv measurements at the parrot. So i just aimed a table fan to the csst section and to my surprise, the product temperature quickly went down.

I am now giving it a shot with csst into an aircooled setup.

Currently building another shotgun reflux condensor using the csst instead of transmission cooler/radiator sections.

I will be following this closely. Im interested to see if the csst will work and if the surface area will be enough.

Seems like there's many ways to skin a cat