This is a 100% rye wash that I've done a few time before: 36 lbs. unmalted rye, 9 lbs. malted rye, and 20 gallons of water. My OG usually reads about 1.070 (take that with a grain of salt -- I hear that gravity readings on rye washes aren't very reliable).
Last time I ran it, I pressed the wash off the grain with a mop bucket, yielding 17.5 gallons of uncleared wash (which was stripped with steam). This time, I ran all 22 gallons of wash and grain in the fermenter.
As I expected, it proved MUCH easier to separate the spent grain from the stillage after distillation than to separate the grain from the wash before distillation. And my compost bin smelled much less suspicious!
But what I didn't expect was just how much more yield this one change would produce: My earlier 17.5 gallon wash run yielded 4.75 gallons of low wines at 32% ABV; this time, I produced 6 gallons of low wines at 30% ABV. That's more than an 18% increase in yield!
One more interesting datum (at least to me): my back-of-the-envelope calculations suggest that, at the beginning of fermentation, my fermenter held 23.6 gallons of grain and water. After two weeks, it was down to 22 gallons -- presumably that extra gallon and a half blew off as CO2...