Coper Coil SS End Cap Help

[Gr8brewer]

I Am unable to come up with a good way to mount my coil I would like to mount it via some sort of bulkhead flair or compression fitting. Has anyone done this. If I take it to a welder can stainless be welded to copper?

Thanks,
M

[kiwistiller]

are you struggling to hold it at the right height? Mine has a fork stuck in it at the moment I've also used mesh wrapped around it to make the fit snug. but you could just solder on a copper cross piece couldn't you? It doesn't need to be covered.

[LWTCS]

If I take it to a welder can stainless be welded to copper?

Yes

Nickel-Bronze brazing rods with an oxy/acetylene torch set up.

[kiwistiller]

or tig / mig. (rednose informs me)

[LWTCS]

Gr8brewer wrote:
If I take it to a welder can stainless be welded to copper?


Yes

Nickel-Bronze brazing rods with an oxy/acetylene torch set up.

Check that..............

A resounding "yes" then