i recived my cooper pie today and i just wanted to put my plans up to see wat you think of my Pot /Rflux collumn convertable
(from the top to the bottom)
2.5" Copper Pipe Plans:
Pot collumn (convertable)
cap
condenser cloil (20.3cm deep (double helix))
plates (80mm inbetween 2 plates)
space left between bottom plate and male connector (49.5mm)
Add this to make Reflux collumn
female connector
copper pipe 1m (with packaging copper and ss)
male connector
BOILER 20L +
female connector
Boiler
Final plans (coments please)
Moderator: Site Moderator
-
Oaty
- Swill Maker
- Posts: 446
- Joined: Thu Mar 27, 2008 8:42 am
Re: Final plans (coments please)
It's a bit difficult to tell what you are talking about. More detail would help . For your coil I'd suggest Rhodent's design. This is a picture of Hook's take on it.
Notice that the inner and outer coils are split and joined at the bottom with a ' cold finger' and at the top with another pipe. This effectively halves your restriction , doubles your flow and doubles the cooling capacity. This is especially important if you plan on pumping to a reservoir.
Notice that the inner and outer coils are split and joined at the bottom with a ' cold finger' and at the top with another pipe. This effectively halves your restriction , doubles your flow and doubles the cooling capacity. This is especially important if you plan on pumping to a reservoir.
Never refuse to do a kindness unless the act would work great injury to yourself, and never refuse to take a drink-- under any circumstances.
- Mark Twain's Notebook
- Mark Twain's Notebook
-
BigWilly
- Novice
- Posts: 53
- Joined: Sat Sep 01, 2012 8:32 am
- Location: Liverpool , England
Re: Final plans (coments please)
Can anyone point me in the direction of a more detailed description of Rhodent's coil - i can't seem to find it anywhere...