2" column to keg

DangitBuck · Post by **DangitBuck** » Sun Feb 10, 2013 10:04 pm

Hey everybody I have a quick question that hopefully is easy to answer. Would soldering a 2" ferrule to my column (seen here, http://www.hillbillystills.com/Copper_t ... _p/cs2.htm ) connect to a 15.5 gallon sanke keg with a tri-clamp? Or do I have to use the whole copper pipe to keg kit from mile-hi?
This is my first time working with a keg and I've looked around on the sight and can't find a page about keg connections, thanks for your time reading this post!

Post by **Prairiepiss** » Sun Feb 10, 2013 10:18 pm

Search for easy flange. And everlasting PTFE gasket to go with the easy flange.

bellybuster · Post by **bellybuster** » Mon Feb 11, 2013 4:35 am

That piece already has a coupling attached, just slide your column in an solder

Post by **Condensifier** » Mon Feb 11, 2013 4:54 am

I'm going to use this "easy flange" method for the extension I'm going to make for my 3". It looks pretty clean.

http://homedistiller.org/forum/viewtopi ... =2&t=13631

DangitBuck · Post by **DangitBuck** » Mon Feb 11, 2013 5:16 pm

Thanks everybody for the help:) ill definatly try that

condo33 · Post by **condo33** » Mon Feb 11, 2013 5:39 pm

I used the easy flange technique and everlasting PTFE gasket. Probably have a $1:25 in the whole thing and found it very easy to do.

Home Distiller

2" column to keg

2" column to keg

Re: 2" column to keg

Re: 2" column to keg

Re: 2" column to keg

Re: 2" column to keg

Re: 2" column to keg