Pressure cooker

This hobby is fun & enjoyable, but it is not tiddlywinks. Be safe!

Moderator: Site Moderator

Post Reply
firewater706
Novice
Posts: 33
Joined: Fri May 10, 2013 3:55 pm

Pressure cooker

Post by firewater706 »

My wife recently canned some of her world beater chilli,while doing so the bottom of her pressure cooker slightly warped. While I don't feel it is safe to use for canning due to the extreme pressure build up, I feel it will be safe to convert to a still for running of feints and other small ferments.

Does anyone foresee any issues? The pressure from distilling is minimal correct?
Prairiepiss
retired
Posts: 16571
Joined: Sat Dec 18, 2010 7:42 am
Location: Somewhere in the Ozarks

Re: Pressure cooker

Post by Prairiepiss »

I'm guessing its an aluminum pressure cooker? If so then no stainless or copper. This has been discussed at length around here.

Also will have a rubber seal that will need to be replaced. With something hot high ABV alcohol safe.

And generally they are just to damn small to make anything good or any amount of product.

Not to mention this is a dangerous hobby. So you want to start out with structurely sound equipment. So if you don't want to use it for its intended use. Then I wouldn't use it for this use.

Be safe.
It'snotsocoldnow.

Advice For newbies by a newbie.
CM Still Mods
My Stuffs
Fu Man

Mr. Piss
That's Princess Piss to the haters.
firewater706
Novice
Posts: 33
Joined: Fri May 10, 2013 3:55 pm

Re: Pressure cooker

Post by firewater706 »

it's Stainless.
Prairiepiss
retired
Posts: 16571
Joined: Sat Dec 18, 2010 7:42 am
Location: Somewhere in the Ozarks

Re: Pressure cooker

Post by Prairiepiss »

How big is it? Anything less then 5 gal. Makes cuts hard to do. And doesn't produce much of any product. 5 gal is usually the smallest I would recommend.

If it is stainless. I don't know how warping would hurt it to bad. Aluminum would be another story.

But you still need to take care of the seal.
It'snotsocoldnow.

Advice For newbies by a newbie.
CM Still Mods
My Stuffs
Fu Man

Mr. Piss
That's Princess Piss to the haters.
Mazriam
Swill Maker
Posts: 162
Joined: Thu Aug 29, 2013 6:48 am

Re: Pressure cooker

Post by Mazriam »

firewater706 wrote:My wife recently canned some of her world beater chilli,while doing so the bottom of her pressure cooker slightly warped. While I don't feel it is safe to use for canning due to the extreme pressure build up, I feel it will be safe to convert to a still for running of feints and other small ferments.
extreme pressure buildup? I don't really know what kind of pressure cooker you have, but pressure cookers today, by and large have a maximum pressure of 15PSI. (That's less PSI than what's found in your water pipes). In addition, they way pressure cookers keep themselves pressurized is by a weight sitting on top of a nipple. When pressures go above 15PSI, the steam forces it's way past the weight. There is also, a safety relief valve that releases pressure should the weight and nipple, for whatever reason, can't release pressure. Personally, I would not be concerned if my pressure cooker developed a little warping.

But if your looking for plausible sounding excuse, to feed to your wife, to justify stealing her pressure cooker from her, then by all means, warping is unsafe!! :thumbup: :D
ozone39
Rumrunner
Posts: 659
Joined: Sat Dec 12, 2009 9:14 am
Location: Big Sky Country

Re: Pressure cooker

Post by ozone39 »

did she cool it with tap water to speed up cooling?? not sure how else you could warp a s.s pressure cooker....
thinking inside the box is for squares....
firewater706
Novice
Posts: 33
Joined: Fri May 10, 2013 3:55 pm

Re: Pressure cooker

Post by firewater706 »

according to her she did not but the proper amount of water in the bottom of the pot.
Post Reply