I am building an SCR controller using one of the cheapo Chinese all in one modules. I have done several continuity tests to make sure that I have not crossed any wires. Things look good but I have a question about the SCR inputs and outputs. I am using 240V, so both lines in to the SCR are hot.
One of the SCR outputs has continuity with just one of the inputs, but the other output does not have continuity. Not knowing much about the SCR, I am wondering if this is normal?
It's almost smoke test time.
Sent from my SM-N910V using Tapatalk
SCR inputs and ourputs
Moderator: Site Moderator