i can get a SS petes plug,,,,but am concerned about the neoprene gasket inside the plug
any thoughts?
neoprene
Moderator: Site Moderator
-
frodo
- Distiller
- Posts: 1727
- Joined: Sat Dec 07, 2013 11:55 pm
- Location: hiding behind a pine tree. bout 100 miles east of new orleans
neoprene
i want to use a petes plug on top of my boiler. to stick my gauge in,,,it will seal it off
i can get a SS petes plug,,,,but am concerned about the neoprene gasket inside the plug
any thoughts?
i can get a SS petes plug,,,,but am concerned about the neoprene gasket inside the plug
any thoughts?
-
yakattack
- Distiller
- Posts: 1755
- Joined: Sun Nov 16, 2014 5:37 am
Re: neoprene
frodo wrote:i want to use a petes plug on top of my boiler. to stick my gauge in,,,it will seal it off
i can get a SS petes plug,,,,but am concerned about the neoprene gasket inside the plug
any thoughts?
Neoprene = no good. Sorry mate but you already knew the answer to that one. If you can remove it and make one out of PTFE and its all ss then hay why not. But I'm sure there are better solutions available.
HDNB wrote: The trick here is to learn what leads to a stalled mash....and quit doing that.
-
frodo
- Distiller
- Posts: 1727
- Joined: Sat Dec 07, 2013 11:55 pm
- Location: hiding behind a pine tree. bout 100 miles east of new orleans
Re: neoprene
damn.....figured as much, any suggestions i have looked on site, i have not seen this addressed.
or am just missing it.
i have a 1/4'' coupling on top of my boiler,,,i would like a thermometer here
or am just missing it.
i have a 1/4'' coupling on top of my boiler,,,i would like a thermometer here
-
carbohydratesn
- Swill Maker
- Posts: 398
- Joined: Tue Jan 20, 2015 6:37 am
Re: neoprene
Find a thermometer with a probe that screws into the coupling, or make one yourself.
-
frodo
- Distiller
- Posts: 1727
- Joined: Sat Dec 07, 2013 11:55 pm
- Location: hiding behind a pine tree. bout 100 miles east of new orleans
Re: neoprene
- beerchug.gif (2.21 KiB) Viewed 2283 times
thanks for the reply
-
Danespirit
- Master of Distillation
- Posts: 2648
- Joined: Tue Dec 25, 2012 8:09 am
- Location: Denmark
Re: neoprene
You can get those stainless compressionfittings cheap on E bay.
The will fit with ordinary 1/4" NPT.
They are available in several dimentions on the compression ring.
I use one myself. Wrap the thermoprobe in a couple of windings PTFE tape...and it seals well.
Cost are laughable and shipping costs free.
The will fit with ordinary 1/4" NPT.
They are available in several dimentions on the compression ring.
I use one myself. Wrap the thermoprobe in a couple of windings PTFE tape...and it seals well.
Cost are laughable and shipping costs free.
-
InglisHill
- Rumrunner
- Posts: 710
- Joined: Thu Jun 05, 2014 10:37 am
- Location: New Zealand
Re: neoprene
Dane = +1