hi im new to this and thinking of building a still and was wondering about valved reflux still pressure where is it opened to vent pressure?
cheers mav
valved reflux still pressure?
Moderator: Site Moderator
-
mav
- Novice
- Posts: 3
- Joined: Sun Feb 06, 2011 7:10 pm
- Location: gippsland
-
rad14701
- retired
- Posts: 20865
- Joined: Wed Dec 19, 2007 4:46 pm
- Location: New York, USA
Re: valved reflux still pressure?
The valved reflux design often has no cap at the top of the reflux section and if it does it usually has a 3/8" - 1/2" vent hole...mav wrote:hi im new to this and thinking of building a still and was wondering about valved reflux still pressure where is it opened to vent pressure?
That being said, there are easier and cheaper designs that perform just as well if not better than the valved reflux... Check out the Bokakob inline dual slant plate liquid management column... Far less components, dead simple to build, and a proven performer...
Please stop by the Welcome Center and give the membership a proper introduction...